Checking For Leaks; Hydraulic Fluid Capacity; Changing The Hydraulic Fluid - Toro Reelmaster 5010-H Operator's Manual

1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Tilt the seat; refer to
3. At the left side of the machine, align a drain pan
under the charge filter
Figure 118
1. Filter head
4. Remove the filter.
5. Wipe clean the filter mounting area of the filter
head.
6. Apply a thin coat of the specified hydraulic fluid
to the gasket of the new charge filter.
7. Thread the filter onto the filter head by hand until
the gasket contacts the mounting surface, then
rotate the filter an additional 1/2 turn.
8. Lower and latch the seat; refer to
Seat (page 44).

Checking for Leaks

1. Start the engine and run it for 2 minutes to purge
air from the hydraulic system.
2. Shut off the engine, remove the key, and check
for leaks at the return and charge filters.
Note:
Repair all hydraulic leaks.

Hydraulic Fluid Capacity

41.6 L (11 US gallons); refer to
Specification (page 67)
43).
Tilting the Seat (page 44).
(Figure 118).
2. Charge filter
Lowering the
Hydraulic Fluid
Changing the Hydraulic
Fluid
Service Interval: Every 2,000 hours—If you
Every 800 hours—If you are not using the
recommended hydraulic fluid or have ever
filled the reservoir with an alternative fluid,
change the hydraulic fluid.
If the fluid becomes contaminated, contact your Toro
Distributor because the system must be flushed.
Contaminated fluid looks milky or black when
compared to clean fluid.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Place a large drain pan under the 90° fitting
(Figure 119) of the hydraulic tank; refer to
Hydraulic Fluid Capacity (page
g376339
1. 90° fitting (hydraulic tank)
3. Disconnect the cooler-return tube from the 90°
fitting, and allow the tank to drain.
4. When hydraulic fluid stops draining from the
tank, install the tube.
5. Fill the tank with the specified hydraulic fluid;
refer to Hydraulic Fluid Specification (page 67)
and Hydraulic Fluid Capacity (page
Important:
specified. Other fluids could cause system
damage.
6. Install the tank cap.
7. Start the engine, and use all the hydraulic
controls to distribute hydraulic fluid throughout
the system.
69
are using the recommended
hydraulic fluid, change the
hydraulic fluid.
43).
69).
Figure 119
2. Tube (cooler return)
Use only the hydraulic fluids
g379100
69).