Toro Reelmaster 5010-H Operator's Manual page 15

1. Flange locknut (3/8 inch)
2. Right tab (Carrier frame)
5. Align the holes in the turf-compensator bracket
with the holes in the cutting-unit frame
14).
Note:
The support loop of the hose guide aligns
toward the centerline of the machine.
1. Turf-compensator bracket
2. Carriage bolt (3/8 x 1-1/4
inches)
6. Assemble the turf-compensator bracket to the
cutting-unit frame with the 2 carriage bolts (3/8 x
1-1/4 inches) and 2 flange locknuts (3/8 inch).
7. Torque the locknuts and bolts to 37 to 45 N∙m
(27 to 33 ft-lb).
8. Repeat steps 1 through
unit.
Installing the Front Cutting Units
to the Lift Arms
1. Slide a cutting unit under the lift arm
Figure 13
3. Capscrew
Figure 14
3. Flange locknut (3/8 inch)
4. Inboard
7 for the other cutting
(Figure
g375694
1. Cap
2. Snapper pin
2. Assemble the pivot yoke onto the carrier frame
(Figure
shaft.
3. Assemble the cap to the pivot yoke, and align
the holes in the carrier frame shaft, pivot yoke,
and cap.
4. Secure the cap and the carrier-frame shaft to
the pivot yoke with the snapper pin.
Locking the Cutting-Unit Pivot for Cutting
Grass on a Hill Side—Lock the cutting-unit
pivots to prevent the cutting units from rotating
downhill when cutting across the face of a hill.
Use the hole in the pivot yoke
lock the cutting unit. Use the slot for a steering
cutting unit.
g378789
1. Snap-pin positions
2. Hole (lift-arm pivot shaft)
15).
15
Figure 15
3. Pivot yoke
4. Carrier frame shaft
(Figure
Figure 16
3. Slot (lift-arm pivot shaft)
g375274
16) to
g375251