Table 8: Troubleshooting Table - GE JungleMUX SONET Technical Practice

Ethernet - Check the Lost tab info for all relevant ports along the signal path. If
communication
through the given
port has high
latency
- If Rate Limiting is used at near-end and/or far-end ports ensure it is set
- The Aging Time settings for the near-end and/or far-end MAC Address
Copyright  GE Multilin Inc. 2010-2012
excessive discarded traffic is observed, try to do one of the following:
- Increase the amount of SONET bandwidth assigned to the affected
TDM pipe.
- If traffic prioritization is used, check the priority settings for the near-
end and far-end ports. Modify/re-engineer priority settings within the
affected TDM pipe.
as required. If necessary, modify the settings.
Tables may be too low/high. Check if the amount of Broadcast traffic
drops with higher/lower Aging Time settings.
NOTE: For debugging, the user should assign a unique priority for the
port being debugged and use "passed" and "lost" queue counters.

Table 8: Troubleshooting Table

342-86400-498PS
Issue 1.2
April 2012
Page 136