Interfaces; Data Interface - Siemens SIMEAS R-PMU Manual

12

12.7 Interfaces

12.7 Interfaces
The SIMEAS R-PMU features the following communication interfaces:

Data interface

LAN interface
Service interface
12.7.1 Data Interface
The 9-pin serial data interface at the rear panel of your SIMEAS R-PMU can be used for direct
connection, modem connection, X.25 or star coupler. A PDC can be connected directly or via
modem.
Select the Data Interface tab under System control
Figure 12-14 Interfaces, Data Interface tab
Check the Enable Data Interface checkbox and select the interface type from the drop-down
menu Serial Communication Type.
Enter the telephone number for modem transmission or X.25 Address for an X.25
connection in the Telephone number box. The Telephone Number is for documentation
purposes only and can be left empty.
Enter the Star coupler address for the Star coupler under Serial Communication Type.
Select the Baud rate of the interface from the drop-down menu of the Baud rate box.
In the Wait Time after disconnecting (ms) box you can enter a period of time that the
SIMEAS R-PMU will allow to elapse after disconnecting the modem before using the
interface again. This ensures that even slow modems have sufficient time for disconnecting.
146
→
Interfaces.
Digital Fault Recorder, SIMEAS R-PMU, Manual
E50417-H1076-C360-A5, Release 10.2012