Specifications; Power Source; Applicable Signals; Connection Terminals - Sony EBS-SP10 User Manual

Monitors: external tv tuner with hospitality support.

Hide thumbs Also See for EBS-SP10:

Table of Contents

SP-TUNE User Manual

10 Specifications

12v 15 Watt DC wall supply

5.65 Watts Maximum with 12v DC input

Color system: NTSC (RF and AV inputs)

Scanning format: 525i (480i), 525p (480p)

Receiving RF signals – US Standard Air, US Standard Cable, Cable HRC, Cable IRC

Supported audio standards: auto-detection, BTSC-STEREO, BTSC-MONO+SAP

Serial port – RS-232C compatible, can be used for Plasma Display control, firmware update, and

SP-TUNE control/diagnostics. Baud rate – 9600 (for Display control) or 115200 (for other

purposes). 8 bits data, 1 start bit, 1stop bit, no parity bit.

Video IN (RCA)

S-Video IN (Mini DIN 4pin)

Component YPbPr/RGB+HV IN – 15-pin female VGA-compatible connector.

Audio stereo IN/OUT – 8 pin mini DIN. Requires adapter cable with 4 pairs of RCA connectors.

ANT (aerial) IN – RF UHF/VHF

Sony Service Port – RJ11

Component YPbPr/RGB+HV OUTPUT – 15-pin female VGA-compatible connector.

IR IN – 3.5mm TRS (Tip – Signal, Ring – 12v (if jumped internally), Sleeve – Ground)

IR OUT – 3.5mm TRS (Tip – Signal, Ring – NA, Sleeve – Ground)

RS-232 – DB9 Connector (2- RX, 3- TX, 5- Ground)

Logic IN – 3.5mm TRS (Tip – Input Signal, Ring – NA, Sleeve – Ground)

8 Pin Mini-DIN Audio connector pinout:

1 – SVideo audio Right IN

2 – YPbPr audio Left IN

3 – Composite audio Right IN

4 – SVideo audio Left IN

5 – Right Line OUT

Table of Contents