Wbe 4510 - Bosch WBE 4510 Original Instructions Manual

en 38 | WBE 4510 | User information
3.5

WBE 4510

19
18
15
16
17
Fig. 1: WBE 4510
Item Designation
1 TFT monitor
2 Wheel guard
3 Wheel lift operating unit
4 Wheel lift slide
5 Vernier caliper
(electronic)
6 Laser
7 Clamping tool holders
8 Safety device
9 Wheel holder
10 Cone of drive shaft
11 Right pedal
12 Left pedal
13 Operating unit with function keys
14 Tray
15 On/off switch
16 Mains socket
17 Service unit with compressed air con-
nection
18 Centering flange
19 Quick-action clamping nut
20 Manual vernier caliper
21 Measuring compasses
|
1 695 655 163 2010-07-17
1
20
21
14
13
Function/purpose
Software display
+ Protection of operator against flying particles (e.g. dirt, water).
+ Starting and stopping measurement.
Control of wheel lift.
Lifting device; provides assistance on attaching and removing the wheel.
+ Recording of rim distance and rim diameter.
+ Determination of positions for attachment of adhesive weights.
Recording of rim width, true-running and tire geometry.
Storage of cones and quick-action clamping nut.
Safety feature
Securing of wheel on wheel lift slide to prevent tipping.
Flange mounting
Locking of shaft / wheel.
Transfer of rim data (optional, see chapter 8.4.2).
Operation of WBE 4510 via function keys, refer to Section 7.
Storage of balance weights and tools.
Switching WBE 4510 on and off.
Connection for power cord.
+ Checking/adjustment of operating pressure.
+ Removal of dirt.
+ Oil supply for compressed air system.
Wheel attachment.
Centering and attachment of wheel on cone
Can be used as substitute if the vernier caliper (electronic) is defective.
Can be used as substitute if the rim width and rim diameter cannot be recorded
with the vernier caliper (electronic)/laser.
5
2
3
4
10
11
12
6
7
8
9
Robert Bosch GmbH