Change The Switch; Change The Capacitor; Change Motor; Change The Pedal Tension Spring Or Torsion Spring - Bosch Start Line TCE 420 Repair Instructions

5.11

Change the switch

¶
40A switch connection
Power cable: 1, 3
Motor cable: Ground wire—12, red—10, blue—9, black—5
¶
16A switch connection:
Power cable: black—1, red—5, blue—9
Motor cable: black—2, red—6: blue—8
40A switch working method:
R
1-2 connect
3-4 connect
5-6
7-8 connect
9-10 connect
11-12
5.12

Change the capacitor

i
Single motor has capacitor.
!
Must cut off the power supply before change the
capacitor and do the capacitor discharge (short
circuit.
1. Remove the screws on plastic cover then take out
the capacitor.
2. Check the parameter of capacitor and mount the
new one.
Robert Bosch GmbH
O L
connect
connect
connect
connect
Change the components | Start Line TCE 420 | 35
5.13

Change motor

1. Remove the belt.
2. Remove the switch.
3. Loosen the bolt A then remove the motor and motor
support plate.
4. Change motor.
5. Install motor. the poles of capacitor with wire).
6. Connect the switch(refer to Chapter "Change the
switch").
5.14 Change the pedal tension spring or
torsion spring
en
|
1 695 108 084 2016-11-15