Changing The Operation To Be Performed In The Case Of A Disk Fault - Hitachi CE50-10 Instruction Manual

5.9 Changing the operation to be performed in the case
of a disk fault
If a disk fault occurs during the operation of the unit or if a slowdown in the disk access time is detected, a kernel
panic occurs by default. If you want to change this setting so that operation of the unit continues after a disk fault or a
slowdown detection, you need to change the definition file settings.
Definition files
• Definition file for disk faults: /hitachi/etc/dskptrl_stop.conf
• Definition file for slowdown detection: /hitachi/etc/slowdown_stop.conf
Item specified in a definition file
stop definition-value --- (A)
(A)
Specify 0 or 1. The default is 0. To change the operation, change the setting to 1.
Table 5‒6: Definition values of the stop item
Definition value
0
1
A kernel panic (default setting) occurs.
Unit operation continues.
5. Configuring Software Environment
Description
51