Hitachi CE50-10 Instruction Manual page 127

Restoration starts from the selected data, and then the screen is displayed as follows.
Making partitions finished.
OK
Restoring from extra media.
Restoring: 20210525101010_sda8_01.gz
31MiB 0:00:01 [16.1MiB/s] [====>
Will you verify restored area(y / N)?y
Verifying: 20210525101010_sda8_01.gz
The file and the partition doesn't match. Retry?(y / N)
Restoring: 20210525101010_sda8_01.gz
31MiB 0:00:01 [16.1MiB/s] [====>
Finished: 20210525101010_sda8_01.gz
(snip)
Will you verify restored directory(y / N)?
Verifying: 20210525101010_etc_01.tgz
The file and the directory doesn't match. Retry?(y / N)
Finished: 20210525101010_etc_01.tgz
Successfully completed
$
Table 5‒28: Description of the screen after restoration from external media started
Item Display
Making partitions finished.OK
(a)
Restoring from extra media.
(b)
Restoring: 20210525101010_sda8_
(c)
01.gz
(start=0 size=123456)
31MiB 0:00:01 [16.1MiB/s] [====
(d)
> ] 25% ETA 0:00:02
Will you verify restored area(y
(e)
/ N)?y
Verifying: 20210525101010_sda8_
01.gz(start=0 size=123456)
Will you verify restored direct
ory(y / N)?
Verifying: 20210525101010_etc_0
1.tgz
The file and the partition does
(f)
n't match. Retry?(y / N)
The file and the directory does
n't match. Retry?(y / N)
5. Configuring Software Environment
(start=0 size=123456)
] 25% ETA 0:00:02
(start=0 size=123456)
(start=0 size=123456)
] 25% ETA 0:00:02
Description
This message appears when initialization of a partition
finished.
This message appears when restoration from the external
media starts.
This message appears when restoration of the indicated
backup file starts.
If the restoration destination is a partition, the range to be
restored is displayed. Specifically, the number of bytes
from the beginning of the partition to the restoration start
point is indicated for start=, and the size to be restored
(unit: bytes) is indicated for size=.
The progress of restoration of the backup file.
The following are displayed from the left to right:
• Extended capacity
• Elapsed time
• Data transfer rate (amount of transferred data/second)
• Progress bar
• Progress rate (percentage display)
• Estimated remaining time (required for processing)
The displayed progress rate might slightly exceed 100%.
This message asks you whether you want to verify that
restoration to the partition has finished normally.
If you enter y, the message in (f) appears. Then, the backup
file is compared with the checksum of the target partition to
confirm that they match.
If you enter N, the message in (h) appears.
This message appears if an error is detected as a result of
the verification of restored data.
If you enter y, the message in (c) appears and restoration of
the same backup file starts.
If you enter N, Restore aborted. is output to the
standard output and the command terminates.
...(a)
...(b)
...(c)
...(d)
...(e)
...(e)
...(f)
...(c)
...(d)
...(g)
...(e)
...(e)
...(f)
...(g)
...(h)
111