Table of Contents
Advertisement
4-6
Bosch Rexroth AG | Electric Drives and Controls
Technical Data
4.8
Applied Standards and Guidelines
Standards and Guidelines
Interference Immunity
Emitted Interference
Equipment Requirements
Storage and Transportation
Power Supply
Electromagnetic Compatibility
Degrees of Protection
Impact Load, Shocks
Sinusoidal Vibrations
UL/CSA-Certification
4.9
Compatibility Test
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-6-2
EN 55022 Limit Value Class A
EN 6100-6-4
EN 61131
EN 61131 Part 2
EN 61131 Part 2
89/336/EEC (Including all Applicable Amendments)
EN 60529
EN 60068 Part 2-27
EN 60068 Part 2-6
UL508 (Industrial Control Equipment)
C22.2 No. 14-95 (CSA)
This is a class A device. This device may cause radio interference in
residential areas. In this case, the user may be required to introduce ap-
propriate countermeasures, and to bear the cost of same.
You must satisfy the following conditions for a operation in conformity
with the UL/CSA:
• Only use isolated copper wires for at least 60/75 °C (140/167 °F)
• Only use isolated wires of class 1.
The UL/CSA identification only applies to the device in the delivery
state. After changes at the device e.g. after putting additional expansion
boards the UL conformity must be checked.
All Rexroth controls and drives are developed and tested according to
the technological state-of-the-art.
As it is impossible to follow the continuing development of all materials
(e.g. lubricants in machine tools) which may interact with our controls
and drives, it cannot be completely ruled out that any reactions with the
materials used by Bosch Rexroth might occur.
Rexroth IndraControl VCP 35.2 | R911323106 / 02
Advertisement
Chapters
Table of Contents
