ACL Re-Mark Configuration
Re-Marking In-Profile Configuration
© Copyright Lenovo 2017
You can choose to re‐mark IP header data for the selected ACL. You can configure
different re‐mark values, based on whether packets fall within the ACL Metering
profile, or out of the ACL Metering profile.
Table 204.
ACL Re‐Marking Configuration Options
Command Syntax and Usage
default accesscontrol list <1‐256> remark
Sets the ACL re‐mark parameters to their default values.
Command mode: Global configuration
show accesscontrol list <1‐256> remark
Displays current re‐mark parameters.
Command mode: All
The following table displays Re‐Marking In‐Profile configuration commands:
Table 205.
ACL Re‐Marking In‐Profile Options
Command Syntax and Usage
accesscontrol list <1‐256> remark dot1p <0‐7>
Re‐marks the 802.1p value. The value is the priority bits information in the
packet structure.
Command mode: Global configuration
no accesscontrol list <1‐256> remark dot1p
Disables the use of 802.1p priority for in‐profile traffic.
Command mode: Global configuration
accesscontrol list <1‐256> remark inprofile dscp <0‐63>
Re‐marks the DSCP value for in‐profile traffic.
Command mode: Global configuration
no accesscontrol list <1‐256> remark inprofile [dscp]
Deletes the re‐mark in‐profile configuration. The dscp option only disables
the use of DSCP for in‐profile traffic.
Command mode: Global configuration
[no] accesscontrol list <1‐256> remark usetosprecedence
Enables or disables mapping of TOS (Type of Service) priority to 802.1p
priority for in‐profile packets. When enabled, the TOS value is used to set the
802.1p value.
Command mode: Global configuration
Chapter 4: Configuration Commands
433