Problems During Playback From External Devices; No Sound; Sound Is Distorted Or Humming; Wall-Mounting - Silvercrest LT 1510 User Manual And Service Information

Problems During Playback from External Devices

No sound

• Please check if the audio cable is firmly connected.
• Check if the audio cable is damaged.
• Make sure that you have selected the correct signal source on your TV set.

Sound is distorted or humming

• Clean the connector plugs.
• Replace the connection cable to the external device.

Wall-Mounting

You can mount your LT 1510 to the wall by using a VESA wall mount of 75 x 75 mm. The VESA wall-
mounting kit is not included in the package. To do so, disassemble the base as follows:
1. Power the device off and unplug all cables and connectors. For the following steps you'll need
a conventional Philips screwdriver.
2. Lie a soft cloth on an empty, level table and carefully place the LT 1510 with its front on it.
3. Loosen the three screws located inside the base. Next you can pull the base off downwards.
4. Insert the supplied stand hole cover (see page 6 – Package Contents) where the stand was
fixed to the housing and then fix it with 2 of the 3 screws you have removed in the previous
step.
5. Install the VESA wall mount on the back of the monitor. Follow the installation instructions that
came with your wall mount kit.
Keep the base, the socket and the screws in a safe place in case you need to reas-
semble the base again.
Wall-Mounting
43