Parking Lot Sensor | PLS
2.2 Installing the sensor base
To ensure safe installation:
⇒ Install the PLS core (black part) into the PLS base (grey part) only after the final installation of the
PLS base.
⇒ Do not bring a magnet near the PLS (this would power the device).
⇒ Install the PLS core properly into the PLS base.
⇒ Avoid uninstalling and reinstalling the PLS core after the initial installation into the PLS base.
⇒ Do not open the sensor core.
The sensor base is attached to the substrate (e.g., concrete, asphalt). To do this, we recommend a two-component
adhesive. We have already had good experience with the following adhesive: DELO®-PUR 9692 (universal 2-
component polyurethane adhesive available in 50 ml and 200 ml cartridges). We will be happy to support you with
procurement. We recommend installing several sensor bases first and only then inserting the sensor cores.
Required material for installing the parking lot sensor
Figure 2
Material for attachment
1
Disposable gloves (protection against contact with adhesive)
2
Two-component adhesive
3
Adhesive press (these differ, depending on the cartridge size)
4
Mixing tube
5
Tape rule
6
Sensor base
7
Sensor core (sensor)
8
T20 screw
9
Sensor cap (sensor sealing cap)
© Bosch Connected Devices and Solutions GmbH 2021. All rights reserved, also regarding any disposal, exploitation, reproduction, editing,
distribution, as well as in the event of application for industrial property rights.
Warning
4 | 18
Sensor Cap