Bosch PLS User Manual page 10

Hide thumbs Also See for PLS:

Table of Contents

Parking Lot Sensor | PLS

10 | 18

The sensor can be screwed into the base after the adhesive has cured. To simplify insertion, the arrow on the bottom

of the sensor points towards the Bosch logo (see Figure 14 Installing/screwing in the sensor). After inserting the

sensor, it will take approx. 2 minutes until the first measurements are carried out. During this time, the sensor should

be completely screwed in to ensure optimum teaching of the sensor. To tighten it, use the T20 screw and a

T20 screwdriver and tightening torque with at least 1.4 Nm up to a maximum of 1.8 Nm. And then close the opening

with the sensor sealing cap.

Figure 14 Installing/screwing in the sensor

distribution, as well as in the event of application for industrial property rights.

Table of Contents

Tps110