Table of Contents
Advertisement
Initial Scanner Start-Up
11-2
1 Power switch
Switch on the IDH at its power switch (1) at the front (open the lid at
the front of the IDH and press the black "Power" button) and wait for
approx. 1 minute until the boot process has been completed.
Start the WebUI_CCS, see document "Web User Interface Centralized
Computer System WebUI_CCS, SW User Manual".
Check basic scanner functions
Check the LED displays on the scanner: the green and yellow LEDs are
lit up. The red LED is off.
For details on the switch-on behaviour of the CLSC refer to the
documentation "Colour Letter Scanner CLSC3000, Adjustments and
Repair".
Note!
In general, no white reference calibration is necessary after installation
of a new CLSC3000, because calibration was done at the factory.
Note!
In general, no adjustment of the parameter settings for transport speed,
tachometer resolution and light barrier delay should be necessary after
installation of the IDH and its software, because the suitable settings
are stored in a configuration file internally.
2 Reset button
Installation Manual, CLSC004enI3c
© Siemens AG 2010 / Date of issue: 2010-05-19
CLSC3000
Advertisement
Table of Contents
