Table of Contents
Advertisement
CLSC3000
8.1.3
Cleaning Up the Work Place
8.1.4
Checking Safety and Protection Equipment
Installation Manual, CLSC004enI3c
© Siemens AG 2010 / Date of issue: 2010-05-19
General Maintenance and Repair Work Instructions
After completing all the work, prepare the machine for normal operation. To
do this, check the following:
If safety buttons have been pressed or safety switches or fuses switched
off, has the reason been discovered and eliminated?
Have all the tasks been completed correctly?
Ensure that there are no loose or leftover parts, tools, or other materials
(e.g. rags, test cards, etc.) in the machine.
Has the maintenance level been deactivated?
Have all doors and covers, as well as all additional panels, been secured
and closed and locked correctly?
Do you know how to dispose of replaced parts, employed material
(cleaning cloths, cleaning agents) and replaced consumable resources?
Local directives on waste disposal must be observed.
As a final step, check the correct functioning of the safety devices of
the machine. This test has to be completed successfully.
Make sure that all the safety devices are installed according to the
safety task assigned to them.
Remove the barriers from the work place and all the warning signs
connected to this task.
Hand over the machine "ready to start" to your supervisor.
Note!
Handover to the Operating Personnel
Only after successful completion of these tasks can the machine be
handed over to the operating personnel.
General Maintenance and Repair Instructions
8-3
Advertisement
Table of Contents
