Retrofitting The Large-Surface Filter - Miele PG 8063 Operating Instructions Manual

Retrofitting the
large-surface fil-
ter
AD water connec-
tion for
30-1000 kPa (UK:
100-1000 kPa)
pressure - pres-
sure-resistant
(optional)
AD water connec-
tion for 8.5-60 kPa
- without pressure
(optional)
DI water ring line
 Do NOT shorten or otherwise damage the inlet hoses (see dia-
gram).
See installation diagram supplied.
If the water contains a high level of insoluble components, a large-
surface filter can be installed between the stopcock and the water in-
let hose.
The large-surface filter is available from the Miele Customer Service
Department.
This machine can be optionally supplied for a pressurised system op-
erating between 30-1000 kPa (UK: 100-1000 kPa). If the water pres-
sure is below 200 kPa the water intake duration will be automatically
increased.
The pressure tested hose for AD water, coded green, has a ¾ inch

threaded union for connection to the onsite stopcock for AD water.
 If the machine is not going to be connected to demineralised
(DI) water, the DI water connection has to be deactivated by the
Miele Customer Service Department. The intake hose remains on
the back of the machine.
The machine has to be converted for connection to 8.5-60 kPa pres-
sure unless ordered as such at the factory. Installation of the pump
must only be carried out by Miele Service.
With a pressureless AD water connection, the drainage point must
be at least as high as the top of the machine. See installation in-
structions.
The machine can be connected to a ring line system for DI water. For
this purpose, it must be technically adapted and the controls reset by
the Miele Customer Service Department.
Please contact the Miele Customer Service Department for further
information.
Plumbing
119