Process-Related Faults And Messages - Miele PG 8063 Operating Instructions Manual

Problem
Fault 492, 504
Fault 550
Fault 578

Process-related faults and messages

Problem
Wrong code entered
Programme cancelled
Programme continued
Peak load cut-out
All settings reset
Cause and remedy
A programme has been cancelled because there is not
enough spray pressure. The filters in the wash cabinet may
be blocked.
 Danger of injury from glass shards, needles, etc. re-
tained in the filters.
Check and clean the filters in the wash cabinet (see

"Maintenance/Cleaning the filters in the wash cabinet").
The waterproof system has been activated. One of the wa-
ter supply hoses might have a leak.
Close the stopcocks.

Contact the Miele Customer Service Department.

The peak load cut-out has lasted longer than 3 hours.
Have your electrical system and your energy manage-

ment system tested by a suitably qualified person.
Cause and remedy
The PIN code entered is not the same as the code saved.
Enter the PIN code again.

Report the loss of the PIN code to the Miele Customer

Service Department.
This is not a fault.
A programme which was running was cancelled by the
user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
This is not a fault.
The process of cancelling a programme was not com-
pleted.
The programme which was running continued without in-
terruption.
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
This is not a fault.
A user has restored factory default settings.
Confirm the message with OK.

Problem solving guide
105