Mounting Pci Mezzanine Cards - Motorola CompactPCI CPN5365 Installation And Use Manual

Mounting PCI Mezzanine Cards

You can mount one or two +5V and/or Universal PCI Mezzanine Cards
(PMCs) on the CPN5365. Each PMC site is keyed for +5V PCI bus
interface.
Inserting or removing PMCs with power applied may result in damage to
!
module components.
Caution
Note
The upper PMC module I/O (PMC 2) connects to J3 and the lower PMC
module I/O (PMC 1) connects to J5. Signal routing for PMC I/O must be
about one inch to permit use of different types of high speed devices. If you
mount the on-card hard drive you cannot use the upper PMC site (PMC 2).
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Shut down the operating system.
3. Turn AC or DC power off and remove the AC cord or DC power
4. Remove chassis or system cover(s) as necessary.
5. Carefully remove the CPN5365 from its card slot and lay it flat, with
6. Remove the PMC filler from the front panel.
Do not damage or bend connector pins.
!
7. Slide the edge connector of the PMC module into the front panel
Caution
http://www.motorola.com/computer/literature
You cannot install PMC cards that are only compatible with
+3.3V PCI.
strap to the chassis as a ground. Keep the ESD secured throughout
this procedure.
lines from the system.
connectors J1 through J5 facing you.
opening from behind and place the PMC module on top of the base
board. Align the four connectors on the underside of the PMC
module with the corresponding connectors on the CPN5365:
Installing Memory Modules, PMCs, and Drives
1
1-11