• Set the focus to ∞
• Shoot a full-white pattern over the entire frame of the monitor screen.
Adjustment Procedure
1.
Adjust the lens iris until the white level becomes approximately 80%.
2.
Adjust H Saw, H Para, V Saw, and V Para for each of G-channel, B-channel, and R-channel until the waveform
on the waveform monitor becomes flat.
(H SAW)
(H PARA)
4-1-4.
Flare Adjustment
The Flare Adjustment menu enables flare compensation for the respective channels of G-channel, B-channel and R-
channel.
Flare Adjustment
Preparation
• Connect the HD waveform monitor to the SDI OUT connector.
• Set the HD waveform monitor to the RGB mode.
• Shoot a gray-scale chart to fill the entire screen of the picture frame and execute the white balance.
• Set the Knee of PICTURE PROFILE menu to the Auto or Off.
Adjustment Procedure
1.
Adjust lens iris until white level (portion A) becomes approximately 100%. After that, open the lens iris by two
stops.
2.
Select waveform of the signal at the center of grayscale signal on a waveform monitor.
MCC-3000MT
(V SAW)
(V PARA)
A
4-3