3-1.
Overview
3-1-1.
Service Menu Structure
The Service menu consists of the three ordinary setup menus and the following three dedicated service menus.
Menu Item
MAINTENANCE
RPN CORRECT
INFORMATION
This section explains the RPN CORRECT menu and the INFORMATION menu. Refer to
for the adjustment by the MAINTENANCE menu.
3-1-2.
Preparation
Connect a monitor to the HD SDI OUT connector.
Note
If an HD SDI monitor is not available, the menu can be adjusted by connecting a monitor to the ANALOG COMPONENT
OUT connector.
3-1-3.
Basic Menu Operations
Activating and Operating the Menu Mode
Press the MENU button to enter the menu mode. Press the PICTURE PROFILE button or the MENU button while the
menu is displayed to close the menu display. The menu display is closed when the power is turned off.
1.
Press the MENU button.
The system enters the menu mode.
2.
Rotate the SEL/SET knob to move the cursor to the desired setting item and press the SEL/SET knob.
Exiting the Menu Mode
1.
Press the MENU button again.
The system exits the menu mode to return to the normal camera mode.
3-1-4.
Displaying the Service Menu
To display the service menu, press the CANCEL button, the MENU button, and the SEL/SET knob at the same time.
Pressing the MENU button again closes the service menu display.
Note
Once the SERVICE menu has been displayed, simply pressing the MENU button displays the SERVICE menu instead
of the normal SETUP menu unless the power is turned off.
MCC-3000MT
Section 3
Service Menu
Description
Adjustment of parameters
Operations regarding the RPN correction
Display of information on this unit and self-diagnosis
"4. Electrical Alignment"
3-1