Table of Contents
Advertisement
2-2. BDKP-E1002 Installation
2-2. BDKP-E1002 Installation
Install the BDKP-E1002 (DPR-93 board) on the APR-25
board.
Installation procedures
1. Remove the APR-25 board from the BDX-E1000.
(Refer to the Section 2-1.)
2. Fix the four PCB holders supplied with the BDKP-
E1002 to the APR-25 board.
PCB holders
3. Match the connectors CN401 and CN402 on the DPR-
93 board with the connectors CN401 and CN402 on
the APR-25 board.
4. Connect the connectors on the DPR-93 board to the
connectors on the APR-25 board while inserting the
PCB holders through the holes on the DPR-93 board.
n
Make sure that the connectors are connected tightly.
CN402
CN402
2-2 (E)
APR-25 board
CN401
DPR-93 board
PCB holder
CN401
APR-25 board
5. Insert the APR-25 board into the Slot No.3. (Refer to
the Section 2-1.)
6. Install the board retainer with the four screws.
7. Close the front panel.
8. Tighten the locking screw.
Confirmation after installation
n
In this section, describes the DVR-2000/2100 (4:2:2
Component Digital VTR) is an example as the equipment
which has the SDI output (CH5 to CH8) capability.
Perform the following confirmation if the DVR-2000/2100
(or the equivalent) is available.
1. Connect the equipments.
<Connection example>
DVR-2000/2100
XLR-to-BNC adaptors ( )
SERIAL V/A OUT
ADVANCE OUT
CH3 (CH - 3/4)
ADVANCE OUT
CH1 (CH - 1/2)
SDI INPUT
AES/EBU INPUT
CH5/6
AES/EBU INPUT
CH7/8
* : CANARE BCJ-XJ-TRA or the equivalent.
*
BDX-E1000
MONITOR
OUTPUT
R
L
R
L
Speaker
system
BDX-E1000
Advertisement
Table of Contents
