Operation via PG/PC (B4)
Software installation
3.2.4
Start program
Program call
The MMC 102/103 software is started on a PG/PC either
● from the program manager through selection of the "SINUMERIK 840D MMC V2.3"
Figure 3-8
● from the file manager by a double click on file REG_CMD.EXE.
Communication
If no communication link can be set up to the NCK or 611D, then the message "No
communication to NCK" is displayed. If communication is interrupted, e.g. by an NCK reset,
then the MMC 102/103 software tries to re-establish the communication link itself.
3.2.5
Close program
Deselect the program
The following steps must be taken to deselect the MMC 102/103 software:
1. Press function key F10
2. Press function key Shift + F9.
3. You can close the program by pressing the Exit softkey.
276
program group followed by a double click on the "MMC Startup" symbol or
SINUMERIK 840D MMC program group
A horizontal softkey bar is displayed.
Function Manual, 03/2009, 6FC5397-1BP10-4BA0
Extended Functions