Yamaha 006IPTO-F0 Owner's Manual page 321

COMP 5.1
Six input, six output compressor for 5.1 surround,
with individual solo for each band, and gain reduc-
tion metering of left and right (L+R), left surround
and right surround (LS+RS), center (C), or LFE
channels.
Parameter Range
LOW GAIN –96.0 to +12.0 dB Low band level
MID GAIN –96.0 to +12.0 dB Mid band level
HI. GAIN –96.0 to +12.0 dB High band level
For positive values, the threshold
of the high band is lowered and
the threshold of the low band is
PRESENCE –10 to +10 increased. For negative values,
the opposite will occur. When
set to 0, all three bands are
affected the same.
THRE. –24.0 to 0.0 dB Compressor threshold
1:1 to ∞:1
RATIO Compressor ratio
ATTACK 0–120 ms Compressor attack
1
RELEASE Compressor release time
KNEE 0–5 Compressor knee
LOOKUP 0.0–100.0 ms Lookup delay
2
KEY LINK Key-in linking
L–M XOVR 21.2 Hz–8.00 kHz Low/mid crossover frequency
M–H XOVR 21.2 Hz–8.00 kHz Mid/high crossover frequency
SLOPE –6 to –12 dB Filter slope
–6.0 to 0.0 dB, Specifies the maximum output
CEILING
OFF level
If this is on, only the low-fre-
SOLO LOW OFF, ON
quency band will be output.
If this is on, only the mid-fre-
SOLO MID OFF, ON
quency band will be output.
SOLO If this is on, only the high-fre-
OFF, ON
HIGH quency band will be output.
1. 6 ms–46.0 s (fs=44.1 kHz), 5 ms–42.3 s (fs=48 kHz), 3 ms–23.0 s
(fs=88.2 kHz), 3 ms–21.1 s (fs=96 kHz)
2. 5.1: Key-in's of all inputs are linked
5.0: Key-in's of L, C, R, LS, and RS are linked (LFE is independent)
3+2: Key-in's of L, C, and R, and key-in's of LS and RS, are linked
respectively (LFE is independent)
2+2: Key-in's of L and R, and key-in's of LS and RS, are linked
respectively (C and LFE are independent)
COMPAND 5.1
Six input, six output compander for 5.1 surround,
with individual solo for each band, and gain reduc-
tion metering of left and right (L+R), left surround
and right surround (LS+RS), center (C), or LFE
channels.
Description Parameter
LOW GAIN –96.0 to +12.0 dB
MID GAIN
HI. GAIN
PRESENCE
THRE.
RATIO
ATTACK
RELEASE
WIDTH
TYPE
LOOKUP
KEY LINK
L–M XOVR
M–H XOVR 21.2 Hz–8.00 kHz
SLOPE
CEILING
SOLO LOW OFF, ON
SOLO MID
SOLO
HIGH
1.
2.
Other preset effects (COMP276, COMP276S,
COMP260, COMP260S, EQUALIZER601, OPEN-
DECK, REV-X HALL, REV-X ROOM, REV-X
PLATE) are optional Add-On Effects. For more
information on these effects, refer to the Owner's
Manual that came with the Add-On Effects pack-
ages.
Effects Parameters
Range
Low band level
–96.0 to +12.0 dB Mid band level
–96.0 to +12.0 dB High band level
For positive values, the threshold
of the high band is lowered and
the threshold of the low band is
–10 to +10 increased. For negative values,
the opposite will occur. When
set to 0, all three bands are
affected the same.
–24.0 to 0.0 dB Compressor threshold
1:1 to 20:1 Compressor ratio
0–120 ms Attack time
1
Release time
Compressor effect range and
1–90 dB
expander effect width
Soft, Hard Compander type
0.0–100.0 ms Lookup delay
2
Key-in linking
21.2 Hz–8.00 kHz Low/mid crossover frequency
Mid/high crossover frequency
–6 to –12 dB Filter slope
–6.0 to 0.0 dB, Specifies the maximum output
OFF level
If this is on, only the low-fre-
quency band will be output.
If this is on, only the mid-fre-
OFF, ON
quency band will be output.
If this is on, only the high-fre-
OFF, ON
quency band will be output.
6 ms–46.0 s (fs=44.1 kHz), 5 ms–42.3 s (fs=48 kHz), 3 ms–23.0 s
(fs=88.2 kHz), 3 ms–21.1 s (fs=96 kHz)
5.1: Key-in's of all inputs are linked
5.0: Key-in's of L, C, R, LS, and RS are linked (LFE is independent)
3+2: Key-in's of L, C, and R, and key-in's of LS and RS, are linked
respectively (LFE is independent)
2+2: Key-in's of L and R, and key-in's of LS and RS, are linked
respectively (C and LFE are independent)
DM1000 Version 2—Owner's Manual
321
Description