Yamaha 006IPTO-F0 Owner's Manual page 251

Assigning Parameters to Control Changes for Real-time Control
4 Move the cursor to the MODE parameter's TABLE button (
[ENTER].
The MODE parameter determines which MIDI messages are transmitted when DM1000
parameters are adjusted. The following options are available for the MODE parameter:
• TABLE............................MIDI Control Change messages are transmitted in accordance
• NRPN.............................The assignments on the Ctl Asgn page are ignored, and pre-
Tip: NRPNs are special MIDI messages that combine three different Control Changes. They
enable you to control many parameters on a single MIDI Channel.
5 Move the cursor to a parameter box in the No. (CH) column, then rotate the
Parameter wheel or press the [INC]/[DEC] buttons to select the Control
Changes to which you want to assign parameters.
You can assign parameters to up to 16-channel Control Changes on the Ctl Asgn page,
regardless of the MIDI Channels currently selected for transmission and reception.
Skip Steps 5 and 6 if you turned on the NRPN button in Step 4.
6 Select parameters in the parameter boxes in the three PARAMETER columns.
Select a parameter group in the parameter box in the first PARAMETER column, and spec-
ify the desired values in the parameter boxes in the second and third PARAMETER col-
umns.
The following parameters and values are available:
HIGH
NO ASSIGN
CHANNEL
MASTER
AUX1 SEND
AUX2 SEND
AUX3 SEND
FADER H
AUX4 SEND
AUX5 SEND
AUX6 SEND
AUX7 SEND
AUX8 SEND
BUS TO ST
CHANNEL
MASTER
AUX1 SEND
AUX2 SEND
AUX3 SEND
FADER L
AUX4 SEND
AUX5 SEND
AUX6 SEND
AUX7 SEND
AUX8 SEND
BUS TO ST
with the assignments on this page.
defined NRPNs (Non Registered Parameter Numbers) are
transmitted for remote control.
MID
—
INPUT1–48
BUS1–8/AUX1–8/STEREO
INPUT1–48
BUS1–8
INPUT1–48
BUS1–8/AUX1–8/STEREO
INPUT1–48
BUS1–8
251
1
), then press
LOW
—
DM1000 Version 2—Owner's Manual
18