Clp-370: Keyboard Stand Assembly - Yamaha Clavinova CLP-100 Owner's Manual

CLP-370: Keyboard Stand Assembly

CAUTION
• Assemble the unit on a flat floor surface.
• Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble the
unit in accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of incorrect
screws can cause damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of the unit.
• To disassemble the unit, reverse the assembly sequence given below.
Have a Philips-head (+) screwdriver of the appropriate size ready.
Remove all parts from the package and make sure you have all of the items.
A
Foamed styrol pads
Remove foamed styrol pads from the package, position them
on the floor, then place A on top of them.
Position the pads so that they will not block the speaker box
on the bottom of A.
B
C
A bundled pedal cord is attached to the reverse side.
D E
CLP-370: Keyboard Stand Assembly
Assembly Parts
6 x 25 mm long screws x 4 4 x 20 mm tapping
screws x 4
6 x 16 mm short screws x 6 Cord holders x 2
4 x 12 mm thin screws x 2
Headphone hanger
4 x 10 mm thin screws x 2 Headphone hanger
Power cord
CLP-370/340/330, CLP-S308/S306 Owner's Manual
81