Yamaha Clavinova CLP-100 Owner's Manual page 28

Selecting & Playing Voices
3.
Select a voice for the right hand.
Press a voice button.
4.
Select a voice for the left hand.
Press the corresponding voice button while holding the
indicator of the Left Voice button will light while the
To turn the variation on or off for the split voice, hold the
press the
[VARIATION]
5.
Exit Split mode and return to normal play mode.
Press the
[SPLIT]
28
CLP-370/340/330, CLP-S308/S306 Owner's Manual
button or the currently-selected voice button.
button again so that its indicator goes out.
button. (The
[SPLIT]
button is pressed.)
[SPLIT]
[SPLIT] button and
NOTE
[VARIATION] in Split Mode
You can turn the variation on or off
for Split mode voices. Normally,
the voice indicator of the right
voice lights in Split mode. The
[VARIATION] can be used to turn
the variation for the right voice on
or off as required. While the
[SPLIT] button is held, however,
the voice indicator of the left voice
lights. In this state the [VARIA-
TION] button turns the variation
for the left voice on or off.
NOTE
[REVERB] in Split Mode
The reverb type assigned to the
right voice will take priority over
the other. (If the reverb of the right
voice is set to OFF, the left voice's
reverb type will be in effect.)
NOTE
[EFFECT] in Split Mode
Depending on the conditions, one
effect type will take priority over
the other. The depth will be
decided according to the depth
default value of the voice combi-
nation. However, using function
F4 (page 65) you can change the
depth value for each voice as you
like. Effect depth setting via the
panel controls (i.e. pressing the
[–/NO] or [+/YES] buttons while
holding the [EFFECT] button —
will be applied to the right voice
only.