Siemens SINUMERIK 840D sl Configuration Manual page 81

Note
Conflicts due to names, addresses or numbers that are used multiple times
When you paste objects from a reference project whose names have already been used in
the project, these are automatically renamed under certain circumstances:
● If you copy objects with the same name into the same folder or the same group, the
● If you copy objects with assigned names to a different folder (or group), the newly pasted
A check for duplicate block numbers or addresses is only done during the conversion,
however.
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
"Conflicts when copying" dialog is displayed.
objects are renamed without asking.
4.7 Copying blocks from one project into another
Programming the PLC
81