Multiplier For Call Charge Factor; Extension Call Charge Factor - Siemens HiPath 1100 Series Programming Manual

Step by Step
1
...
0 0 0
1
Enter the decimal separator position (0 to 4)
For example, for $ 0.12: 00012 and 2
For example, for $ 2.00: 00002 and 0
Initial state for Programming Mode.

Multiplier for Call Charge Factor

This setting specifies the multiplier for Call Charge
factors.
The default setting specifies that each pulse be multi-
plied by 1 for both factors.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 2
or Select a Call Charge factor:
2
= Factor 1
1
= Factor 2
2
Select a pulse multiplier.
2 5 4
Initial state for Programming Mode.

Extension Call Charge Factor

This setting specifies if there is a factor for billing the
users.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 3
Enter the extension number (e.g., 11/101).
... Select a billing factor for the extension:
3
= None (default) - equivalent a billing value of x1
1
= Factor 1
2
= Factor 2
3
Enter the next extension number
or
General Programming
83