Siemens HiPath 1100 Series Programming Manual page 23

Step by Step
or
4 5
...
0 1
Wait 5 seconds
or
4 5
...
0 1
Wait 5 seconds If no new number is entered after 5 seconds, the
In addition to speed-dial numbers, the telephones
configured for Outward-Restricted Trunk Access (with
Permission List) can only dial numbers that start with
these combinations. When any other number is dialed,
the phone answers with a busy signal.
The Permission List already contains some combina-
tions. These can be deleted if so desired.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 4
or Enter the number for the Permission List.
6
Enter the phonebook entry number for the number to
2 5
be allowed access.
Enter the number that will be allowed access (up to 16
digits).
Warning: Enter the number without the external access
code.
Wait for a confirmation tone.
Initial state for Programming Mode.
To change an allowed number just enter its list
entry number and the new number.
Deleting Numbers from a Permission List
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 4
or Enter the number for the Permission List.
6
Enter the list entry number of the number to be delet-
2 5
ed.
content of that entry is removed.
Initial state for Programming Mode.
Main Configurations
23