Mode Of Operation - Siemens HiPath 1100 Series Programming Manual

Programming a Digital Trunk
Step by Step
, ,
0 1 0 2 0 3
1
118
Press this key.
#
Initial state for Programming Mode.

Mode of Operation

This setting specifies the type of connection, either
Point-to-Multipoint or Bus S
digital lines and the local carrier's lines.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 0
or Enter the S
1 1
Enter the slot for the S
0 0
or
...
0 0
0 0
module use Slot 11 and Port 00 to... 04).
... Select the type of connection for the external digital
3
line.
= Point-to-Point (PP - default for the first port)
1
2
= Point-to-Multipoint (PMP)
= Bus S
3
for HiPath 1130/1150 or HiPath 1190
Enter the next module slot
or
• Press this key.
#
Initial state for Programming Mode.
HiPath 1120 cannot be programmed as S
With other systems, the first port may also be
configured as an S
1.Enter the slots for the modules: HiPath 1120 (02), HiPath 1130/1150
(03), and HiPath 1190 (01 and 11).
Module slot on the system
0
module slot:
0
= for HiPath 1120;
0 1
= For HiPath 1130/1150;
0 4
... = For HiPath 1190 (for the second
0 4
connection (default for all other ports) only
0
0
, between the system's
0
1
.
bus.
Bus.
0