Solderless Terminals; Figure 4-1 Connecting Cable Wires And Solderless Terminal Together - Hitachi HSC-2100 Hardware Manual

4 WIRING

4.1 Solderless Terminals

When connecting cable wires to a terminal block, use solderless terminals or crimp terminals.
The following shows two different types of solderless terminal and how to crimp such terminals
to cable wires.
Solderless terminal
Ring-style terminal
7 or less
Example: R1.25-3

Figure 4-1 Connecting Cable Wires and Solderless Terminal Together

Spade-style terminal
7 or less
6
Example: 1.25-YS3A
(Unit: mm)
Connecting cable wires and
solderless terminal together
Heat-shrunk tubes
Cable
Shield wire
Cover each of the crimped joints between a cable and
terminals, and the cable end, with an insulating cap, heat-
shrunk tube, or insulating tape. The purpose of this is to
prevent any accidental short circuit caused by a contact of
those joints with other terminals.
4-2
Solderless terminal