Advertisement
ViewPoint 8650C
User Guide
Table 5-1 IP address planning
Name
SC
Computer / Data
Base
8650C
Table 5-2
Table 5-2 Participant data planning
Site Name
Site1
Site2
Site3
Define each IP terminal as an IP participant on the RM and an endpoint on SC respectively.
The IP terminal, IP participant, and endpoint are associated by the same terminal number. The
IP participant should meet the following requirements:
5.1.2 Configuring the Parameters Between the 8650C MCU and
the RM
To use a terminal to hold a conference with the RM, the SC, and the MCU, you need to set the
connection parameters for the MCU and the RM.
Step 1 Log in to the 8650C web interface.
Step 2 Choose Settings > System > RM Connection.
The RM Connection page is displayed, as shown in
Issue 10 (2013-07-20)
IP address
200.53.24.11
200.53.24.11
200.54.1.101
shows the participant data planning.
Terminal Number
0100001
0100002
0100003
Terminal number: The parameters on the RM (terminal number of the IP participant), the
SC (Endpoint number) and the terminal (terminal number) must be consistent with each
other.
Terminal password: If the SC adopts the password authentication, the terminal password
of the IP participant defined on the RM, the node password defined on the SM, and the
registration password of the IP terminal should be the same.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Holding a Simple Conference
Subnet mask
255.255.0.0
255.255.0.0
255.255.0.0
Other Information
Device type: Terminal
Site type: IP
Rate: 768 kbit/s
Password: 123456
Contact: Rose
Telephone: 01087654321
Email: rose@rmcc.com
The Email notification function is not
enabled.
Figure
5-1.
Gateway address
200.53.0.1
200.53.0.1
200.54.0.1
36
Advertisement
