1. Fuel hose 1 (fuel tank to fuel hose 2)
2. Canister
3. Canister holder
4. O
sensor coupler
2
5. Neutral switch coupler
6. Fuel pump lead
7. Fuel tank breather hose (fuel tank to canister)
8. Fuel tank drain hose
9. Starter motor lead
10. Canister purge hose (hose joint to canister)
11. Canister bracket
A. Route the neutral switch lead and O
to the front of and under the fuel tank breather
hose (fuel tank to canister).
B. Point the ends of the hose clamp in the direction
shown in the illustration.
C. Install the fuel tank breather hose (fuel tank to
canister) with its yellow paint mark facing upward.
D. Install the canister with its stamped mark facing
upward.
E. To throttle bodies
F. To fuel tank
G. Install the fuel tank breather hose (fuel tank to
canister) with its white paint mark facing outward.
H. Install the canister purge hose (hose joint to
canister) onto the canister so that the end of the
hose is pointing in the direction of the arrow shown.
sensor lead
2
2-50
CABLE ROUTING