Yamaha YZF-R1 Series Service Manual page 256

2. Tighten:
• Lower bracket pinch bolts "1" and "2"
Lower bracket pinch bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
TIP
Tighten each bolt to 23 N·m (2.3 kgf·m, 17 lb·ft)
in the order pinch bolt "1" → pinch bolt "2" →
pinch bolt "1" → pinch bolt "2".
3. Tighten:
• Cap bolt "1"
TIP
Tighten the cap bolt "1" using the front fork cap
bolt wrench "2".
Front fork cap bolt wrench 42mm
90890-01575
YM-01575
Front fork cap bolt
20 N·m (2.0 kgf·m, 15 lb·ft)
• Handlebar bolt "3"
Handlebar bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
• Handlebar pinch bolt "4"
Handlebar pinch bolt
32 N·m (3.2 kgf·m, 24 lb·ft)
FRONT FORK (for YZF-R1M)
• Upper bracket pinch bolt "5"
4
TIP
1
When installing the front fork legs, make sure
that the front fork stepping motor couplers are
2
positioned at the angles shown in the illustration.
10°
4. Check:
• Cable routing
TIP
Make sure the brake hose, throttle cables, clutch
cable, and handlebar switch leads are routed
properly. Refer to "CABLE ROUTING" on page
2-17.
5. Adjust:
2
• Spring preload
• Rebound damping
• Compression damping
1
Refer to "ADJUSTING THE PRELOAD OF
THE FRONT FORK LEGS (for YZF-R1M)"
on page 3-23 and "ADJUSTING THE DAMP-
ING FORCE OF THE FRONT FORK LEGS
AND REAR SHOCK ABSORBER ASSEM-
BLY (for YZF-R1M)" on page 3-23.
4-107
Upper bracket pinch bolt
26 N·m (2.6 kgf·m, 19 lb·ft)
3
1
10°
5
10° 10°