Multi Speed Block (Multi Speed) - GE AV-300i User Manual

Jog src
Jog 0 src
Jog cmd src
Jog sel 0 src
Jog sel 1 src
Jog invers src
Jog cfg
Jog 0
Jog 1
Jog 2
Jog 3
Jog acc dlt spd
Jog acc dlt time
Jog dec dlt spd
Jog dec dlt time
Jog mon
Jog 0 mon
Jog sel mon
Jog output
Jog state

1.8.4 Multi Speed Block (Multi Speed)

This Block allows to set up to 8 Internal Speed references, one of which is supplied with the Speed 0 Reference
function. Three selection inputs allow to activate on the output the desired Speed.
Through the Mtl spd s 0 src, Mtl spd s 1 src, Mtl spd s 2 sources, it is possible to select the origin of the signals
stating the input combination (they are standard connected to NULL).
The Mtl spd 0 src source states the origin of the Speed 0 Reference signal (it is standard connected to Mtl spd 0).
The 8 chosen speeds can be set in the configurations via Mtl spd 0 – 7. The following table lists the possible
combinations of the three inputs stating the active Speed (0-7):
Mtl spd sel 2 src
0
0
0
0
1
1
1
1
Speed 0 is usually active
It is possible to monitor the Block output, the state of the Speed 0 Reference and the output active Speed.
AV-300i Version 2 User's Guide
Reference source for Jog 0
Source for the Jog Block activation command
Bit 0 source for the selection of the active Jog reference
Bit 1 source for the selection of the active Jog reference
Source for the Jog reference inversion command
Jog 0 speed
Jog 1 speed
Jog 2 speed
Jog 3 speed
Delta speed acceleration for the Jog ramp
Delta time acceleration for the Jog ramp
Delta speed deceleration for the Jog ramp
Delta time deceleration for the Jog ramp
Monitor for the Jog 0 reference value
Monitor for the active Jog speed
Jog Block output
Jog Block state
Mtl spd sel 1 src
0
0
1
1
0
0
1
1
—————— Function Description ——————
Mtl spd sel 0 src
0
1
0
1
0
1
0
1
ACTIVE SPEED
Multi speed 0
Multi speed 1
Multi speed 2
Multi speed 3
Multi speed 4
Multi speed 5
Multi speed 6
Multi speed 7
TAV3 i0 1 1
Ch.1
97