Fig. 8-1: Position Of The Hard Disk's Installation Frame And The Retaining Screw - Bosch Rexroth IPC 40.2 Project Planning Manual

IPC 40.2
DOK-SUPPL*-IPC*40.2***-PR02-EN-P
1. Save all required user data as well as the operating system settings
of your system on an external storage medium or via the network
connection!
2. Disconnect the power supply.
3. Wait until the power supply unit switches off automatically after UPS
operation (the UPS LED on the IPC flashes red until the UPS
switches off the power supply unit). If required, unplug all connectors
and the battery cable at interface X19.
4. Loosen the retaining screw of the hard disk's installation frame on the
bottom side of the IPC 40.2 (see Fig. 8-1). Lift the hard disk frame
and after releasing the retaining spring unplug the ribbon cable, with
which the hard disk is connected to the main board. Now, the
installation frame with hard disk can be removed.
Fig. 8-1: Position of the hard disk's installation frame and the retaining screw
5. The new hard disk is delivered including the installation frame. The
new hard disk is always mounted with the installation frame in reverse
order as described above.
Note: Check the cable connections leading to the hard disk and the
interface connectors for tightness and verify, if the power
supply is ready for use.
6. The new hard disk parameters are automatically recognized by the
system. If the operating system does not boot automatically after
switching on the IPC 40.2, interrupt the power supply for at least 10
seconds and restart.
7. After properly booting the PC the user data and the operating system
settings for the normal operating mode have to be restored.
Maintenance and Installation
Retaining screw
Hard disk frame
Festplattentausch.FH9
8-3
Display,
rear view