Sony DVCAM DSR-PDX10 Service Manual page 221

DSR-PDX10/PDX10P
2-3-21. Gear Cover C, Pinch Driving Arm Assy, Cam Gear B
1. Removal procedure
1) Remove the screw (M1.4 × 2) 1.
2) Move the key slot of the gear cover C in the direction of the
arrow A and remove the gear cover C.
3) Remove the pinch drive arm assy.
4) Remove the cam gear B.
Setting the cam gear B position
Cam gear B
Hole of the phasing
pin alignment gear
Hole of
chassis
Cam gear B shaft
Pinch drive arm assy
Pinch drive pivot shaft
When attaching it, coat the hatched
Phasing pin alignment
position (hole of chassis)
Dowel
Cam gear B
portion with grease.
2. Attachment procedure
1) Identify the front side and the rear side of a cam gear B. Align
the cam gear B shaft, the gear phasing hole and the LS chassis
hole. Then attach the cam bear B. coat groove of a cam gear
with grease (1/2 drop).
2) Align the pinch drive arm assy with the pinch drive pivot shaft.
While aligning dowel with the cam groove of the cam gear B,
insert the pinch drive arm assy.
3) Insert the "one-step bent portion" of gear cover C into notch of
the chassis, insert the cam gear B shaft into the key hole of the
gear cover. C.
4) Insert the gear cover C into the pinch drive pivot shaft and fix
it with the screw (M1.4 × 2) 1. After tightening the screw
(M1.4 × 2) 1, move the gear cover C in order to confirm that
there is a little play.
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
1 Screw (M1.4 × 2)
Cam gear B shaft
A
Dowel
Fig. 6-2-26.
6-66
Gear cover C
Gear cover C
Pinch drive arm assy
Identify the front side and
the rear side of a cam gear B.
Front Rear
(correct direction) (incorrect direction)
Cam gear B shaft