Troubleshooting; If Damage Is Suspected; If The Film Sheets Jams - Sony UP-DF750 Setup And User's Manual

Troubleshooting

If Damage is Suspected

If a problem appears, check the following trouble shooting
guide first and perform whatever action is recommended to
solve the problem. If the problem persists, turn off the
printer and consult your Sony dealer.
Symptom Possible causes and remedies
Nothing appears on • The 1ON/STANDBY switch on the
the LCD. front panel of the unit is not pressed.
tPress the 1ON/STANDBY switch
• The connections may not be correct.
tMake the connections correctly.
The unit has not The ?/amain POWER switch on the rear
turned on even though panel is not set to on (?).
tSet the ?/amain POWER switch on
the 1ON/STANDBY
switch on the front the rear panel to on (?). (Page 17)
panel is pressed.
The 1ON/STANDBY Set the ?/amain POWER switch to off
(a) once, then set the ?/amain POWER
switch does not work.
to on (?) again. If the 1ON/STANDBY
switch still does not work, turn the power
off and contact you Sony dealer.
The unit does not An error message appears on the window
print. display.
tTake the measures recommended in
"Messages." (page 45)

If the Film Sheets Jams

If a film jam occurs before starting to print or during
printing, the error message "Remove Film XXXXXX"
appears, and printing stops. The "XXXXXX" shows
where the jam has occurred. Check this location and
remove the jammed film. When the film has been removed,
the error message disappears, and image data that have not
yet been output will be printed.
Locations indicated by "XXXXXX" are as follows.
to turn the unit on. (Page 17)
(Page 17)
"XXXXXX" string Countermeasure
(jam location)
Tray 1 (Film tray 1) For information on how to remove
Tray 2 (Film tray 2) film jammed in the film tray, see
page 47.
Rear 1 or 2 (Rear cover 1 For information on how to remove
or 2) film jammed inside the printer, see
Top (Top cover) page 49.
Front (Front cover)
Top & Inner 1 (Top cover
and inner cover 1)
Top & Inner 2 (Top cover
and inner cover 2)
Output tray For information on how to remove
film jammed in the output tray, see
page 50.
Some places (Multiple For information on how to remove
locations) film jammed in multiple locations,
see page 50.
Notes
• When you put your hands inside of the unit, be careful
not to hurt yourself by touching hot or sharp parts.
• If you turn off the power, image data that has not been
printed yet is cleared.
To remove film jammed in the film tray
1
Remove the corresponding film tray.
When the unit is not turned on, you can pull the film
tray out without pushing the EJECT TRAY button.
Notes
• If any printouts have been ejected onto the film tray,
remove them first before removing the film tray.
• When you pull out the film tray, hold both sides of
the film tray and the tray cover with both hands.
47
Troubleshooting