Toro GreensPro 1240 Service Manual page 82

After Repairing or Replacing the Components (continued)
Hydraulic System: Service and Repairs
4. Lubricate the O-rings, ED seals, and dowty seals with clean hydraulic fluid
before installing the hydraulic components.
5. Remove all the caps or plugs from the hydraulic hoses, hydraulic fittings, and
components before connecting them.
6. Use proper tightening procedures when installing the hydraulic hoses and
fittings; refer to Installing the Hydraulic Hoses and Tubes (page 5–12)
Installing the Hydraulic Fittings (page
7. After you complete the repairs, check the control linkages or cables for
proper adjustment, binding, or broken parts.
8. After you complete the repairs, clean any hydraulic fluid from components,
hose connections, and fittings to prevent future accumulation of dirt and
unwanted material.
9. After you disconnect or replace any hydraulic components, operate the
machine functions slowly until the air is out of the system; refer to
the Hydraulic System (page
10. Check for hydraulic fluid leaks; refer to
Hoses (page 5–37). Shut off the engine and repair leaks if necessary.
11. Check the hydraulic fluid level in the hydraulic tank and add correct quantity
of fluid if necessary.
5–14).
5–42).
Checking the Hydraulic Lines and
Page 5–36
and
Charging
GreensPro ™ 1240/1260
14211SL Rev A