Removing the Engine (continued)
GreensPro
™
1240/1260
14211SL Rev A
Use a suitable lifting device to safely raise and support the machine
to get access to the components under the chassis.
2. Unlatch and lift the operator seat pan forward.
3. Remove the exhaust guard if equipped.
4. Disconnect the transmission/hydraulic pump drive collar from the rubber
drive coupling.
Note: On GreensPro 1240 machines, move the hydraulic fluid tank to get
access to the engine wiring connections and engine mounting fasteners. Do
not disconnect the hydraulic fluid lines from the hydraulic fluid tank.
5. On GreensPro 1240 machines, remove the fasteners securing the hydraulic
fluid tank to the chassis
g238090
1.
hydraulic fluid tank
2.
Bolt (2 each)
6. Record the individual connections and disconnect the wire harness from
the engine:
A. Ground wire ring terminal to the blower housing.
B. Two connectors to lighting coil.
C. Two connectors to magneto ignition.
CAUTION
(Figure
9).
Figure 9
(GreensPro 1240)
3.
Lock washer (2 each)
4.
Flat washer (4 each)
Page 4–7
Engine: Service and Repairs