Antenna Settings - Siemens SCALANCE W1780 Configuration Manual

● SNMP
Select the protocol from the drop-down list. The following settings are possible:
– "-" (SNMP disabled)
– SNMPv1/v2c/v3
– SNMPv3
● SNMPv1/v2 Read-Only
Enable or disable write access to SNMP variables with SNMPv1/v2c.
● SINEMA configuration interface
If the SINEMA configuration interface is enabled, you can download configurations to the
device via the TIA Portal.
6.3.1.5

Antenna Settings

Introduction
On this Basic Wizard page, you configure the settings for the external antennas.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03
Access to device parameters via SNMP is not possible.
Access to device parameters is possible with SNMP versions 1, 2c or 3. You can
configure other settings in "System > SNMP > General".
Access to device parameters is possible with SNMP version 3. You can configure other
settings in " System > SNMP > General".
Configuring with Web Based Management
6.3 "Wizard" menu
67