UNIVERGE SV8100
System Hardware Manual
1.
Remove the screw from the front of the PGD(2)-U10 ADP.
Figure 9-2 Remove Cover from PGD(2)-U10 ADP
2.
Using a screwdriver, break out the plastic piece covering the cable hole.
Figure 9-3 Remove Plastic Cover from Cable Hole
3.
Set the S3 – S6 jumpers to the proper settings for the function to be used
(refer to
Table 9-2 PGD(2)-U10 ADP S3 – S6 Jumper Settings on page
9-4).
Issue 2.0
9 - 3