UNIVERGE SV8100
System Hardware Manual
4.3.1
9.5" Base and Expansion Chassis Wall Mount Installation
Optional wall mounting brackets exist for the 9.5" chassis (refer to
Figure 3-70 Optional Wall Mounting Brackets for 9.5"
Option 1 secures the mounting bracket to the wall and the chassis is
attached to the bracket. Option 2 attaches the bracket to the 9.5"
chassis. Then, using the key-holes as a guide, the assembled unit
slides over the screw heads exposed approximately 3/16" out of the
wall.
Figure 3-70 Optional Wall Mounting Brackets for 9.5" Chassis
1.
Use the template shown in
Guide – 9.5" Base and Expansion Chassis on page 3-62
required spacing before drilling.
Figure 3-71 Wall Mount Spacing
Plywood should first be installed on the
wall where the chassis will be positioned.
This allows secure anchoring of the
screws which support the weight of the
chassis.
Issue 2.0
Chassis).
for the
3 - 61