Performing A Hot Start - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
4 - 10
3. Turn the power switch back on to power the system back up.
 With a multi-chassis system, turn on the Expansion Chassis
power supply, then the Controlling Chassis power supply.
4. Continue holding the Load button for approximately three
seconds or until LED 2 starts flashing red.
5. Release the Load button.
6. When the system has completed reloading the software (two
minutes), the Status LED is flashing on the CD-CP00-US.
2.6.2

Performing a Hot Start

The section describes how to load system software from flash
memory and customer data from RAM memory.
System software is loaded from flash memory, and the
customer data is loaded from RAM memory.
1. Turn the system power off.
2. After it has powered down, press the button again to power the
system back up. Wait approximately two minutes.
3. When the system has completed reloading the software, the
Status LED is flashing on the CD-CP00-US.
2.6.3 Resetting the System
This section describes resetting a system that is running. Observe
the important information listed below.
To reset the system:
2.6.3.1 Initial Programming
The system can be programmed using three methods:



IMPORTANT CONSIDERATIONS
Programming using a multiline terminal
PC Programming
Web Programming
UNIVERGE SV8100
Installing the SV8100 Blades