UNIVERGE SV8100
Blade
Slot #
System Hardware Manual
Table 4-2 Adding Daughter Board to Chassis Example
Initial Blade
Blade
1
CD-16DLCA
2
CD-8DLCA
(no daughter
board)
3
CD-16DLCA
—
—
The system automatically recognizes each blade installed in the
system. If a blade was installed previously in a slot and another type
of blade is to be installed in that same slot, the blade must first be
removed from the chassis and then the slot definition removed using
Program 90-05 prior to installing the new blade.
This same condition applies to extensions and other devices
connected to the system. For example, if a port was used previously
for a telephone and a DSS Console is to be installed in that same
port, the telephone must be undefined in Program 10-03 before the
console is connected.
2.2.3
Order of Installing Trunk Blades
2.2.3.1
Extension
Blade
Numbers
Slot #
101~116
117~124
125~140
—
Installing CD-4COTB, CD-4DIOPA, CD-4ODTA or
CD-2BRIA Blades
The order in which trunk blades are physically inserted
determines the numbering plan.
To avoid unexpected extension/trunk
numbering if the VoIP or Voice Mail
daughter board registers with the system
first, install these boards after the other
extension and trunk blades are installed.
Updated Blade
Blade
1
CD-16DLCA
2
—
3
CD-16DLCA
4
CD-8DLCA
(with daughter
board)
Issue 2.0
Extension
Numbers
101~116
—
125~140
141~156
4 - 7