Setting Administrative Parameters - Siemens SICAM Q100 Device Manual

8.3.7

Setting Administrative Parameters

In the Configure tab you can view and if necessary edit the administrative settings. You can select the
parameters in the Administrative menu in the navigation window. These parameters can be changed in the
input/output windows:
• Time synchronization
• Communication Ethernet
• Communication serial
• Modbus slave devices 1 to 8 (only if the Modbus RTU Master protocol has been selected)
• SICAM subdevices
• Device and language
NOTE
Observe the procedure for the device configuration described in chapter 8.3.1 when setting the administrative
parameters.
8.3.7.1 Time Synchronization
Default Settings and Setting Ranges of the Time Synchronization
Table 8-21
Source time synchronization
Time zone offset to UTC
Daylight Saving Time switchover
DST offset
Start of DST
End of DST
Additional Parameters if the Source is Ethernet NTP (Modbus TCP and IEC 61850)
Primary NTP server IP address
Secondary NTP server IP address
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Time Synchronization Settings
Parameter Default Setting
Internal
+00:00
yes
+01:00
March
Last week
Sunday
02:00 AM
October
Last week
Sunday
03:00 AM
192.168.0.254
192.168.0.253
8 Operation at Use of a PC
8.3 Configuration of the Device
Setting Range
Acc. to list box
(see chapter 15)
-12 to +13 (hours)
(in increments of 0.5 h)
no
yes
0 to + 2 (hours)
(in increments of 0.5 h)
Acc. to list boxes
(see chapter 15)
Acc. to list boxes
(see chapter 15)
Any
Any
No polling of the NTP server if
0.0.0.0 was entered
185