Siemens SINUMERIK 840D sl Turning Operating Manual page 669

● Blank
● Spindle chuck data (optional)
● Speed limitation
● If applicable data for the counter-spindle
● Counter-spindle with/without mirroring (for G code)
Parameter
Measurement unit
Main spindle
Work offset
Write to the
work offset
ZV
Blank
XA
XI
ZA
ZI
ZB
N
SW or L
W
L
S
Turning
Operating Manual, 06/2019, A5E44903486B AB
Machine manufacturer
If you are working with pure G code programming, it is possible that the parameter
screen "Multi-channel data" does not open.
Please observe the information provided by the machine manufacturer.
Description
Selecting the measurement unit
Selecting the work offset
● Yes
Parameter ZV is displayed
● No
Parameter ZV is not displayed
Z value of the work offset
For G54, the Z value is entered into the work offset.
Note:
Please observe the information provided by the machine manufacturer.
● Tube
● Cylinder
● Polygon
● Centered cuboid
Outside diameter ∅ – for tube and cylinder
Inside diameter (abs) or wall thickness (inc) – only for tube
Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Number of edges – only for polygon
Width across flats or edge length – only for polygon
Width of the blank - only for centered cuboid
Length of the blank - only for centered cuboid
Speed limitation of the main spindle
Multi-channel machining
11.2 Multi-channel support
Unit
mm
inch
mm
mm
mm
mm
mm
mm
mm
rev/min
669