Settings; Diagnostics - ABB ACS800 Firmware Manual

106

Settings

Parameter
Group 60
78.01,
78.01,
78.04, 78.05, 78.06,
78.07, 78.08
78.09
78.10
10.14
10.15

Diagnostics

Actual signals
02.21, 02.22
02.23, 02.24, 02.25,
02.26, 02.27
03.32 bit 7
03.33 bit 4
Faults
SYNC FAULT
Program features
Additional information
Settings for the Master/Follower application. To be adjusted in the Master
and Follower drives.
78.03 Activation of the Shaft synchro function. To be adjusted in the Master and
Follower drives.
78.02, 78.03, Settings of the Shaft synchro function. To be adjusted in the Follower drive.
Settings of the Synchro error limit. To be adjusted in the Follower drives.
Setting and selection of home position value in case of a homing sequence.
Enables the Shaft synchro function. To be adjusted in the Master and
Follower drives.
Settings for resetting of actual position
Additional information
Actual Position value and Shaft Position value.
Actual Shaft Position error values.
Synchronisation enabled
Synchro Fault
Synchro fault generated in Follower because of position error greater than
the Synchro error limit