GE MDS 4790 Series Installation & Operation Manual page 76

GROUP 1—MAIN SCREENS
Start-up Screen
M D S 4 7 9 0 M A S
R a d i o
O W N E R S N A M E
O W N E R S
Menu Directory
M D S 4 7 9 0A M A S
R a d i o
- >C o n f i g u r a t i o n
D i a g n o s t i c s
E v en t L o g
GROUP 2—CONFIGURATION
Access Level
S e t A c c es s Le v e l
U s e r
Transmit
Frequency
T r a n s m i t F r e q u e n c y
4 00 . 0 0 0 0 0 M H z
68
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx
When the radio first powers on, or after a period of time has elapsed after the last
button press, the front panel shows the start-up screen. The start-up screen shows
the product model number, as well as the owner's name and message (typically,
customers use the owner name and message fields to display the system and site
name).
The screen dims after a period of time has elapsed without activity; restore
brightness by pressing any button.
To change what shows on this screen, see
Owner Message" on Page
Press ENTER, or the up or down arrow button, to show the Menu Directory screen.
The screen dims after a period of time has elapsed without any activity; restore
brightness by pressing any button.
To change what shows on this screen, see
Owner Message" on Page
Press ENTER, or the up or down arrow button, to show the Menu Directory screen.
Use this screen to access three screen display cycles: Configuration,
Diagnostics, and Event Log. The selection arrow (
selected menu.
Press the up/down arrow buttons to move the arrow to the desired menu, then
press the right/left arrow buttons to display each of that menu's screens.
Use this screen to set the front panel screen to configuration mode by selecting a
level of access. There are two levels:
NONE—This is the default setting upon power-up ("safe" mode). You can view
all radio settings, change the access level, and change the front panel screen's
brightness and contrast. All other settings are shown only, and cannot be
changed.
USER—Make changes to any radio parameter ("configuration" mode).
To select the USER access level, press ENTER, press the down arrow button to
display the word "User," then press ENTER again to make the change.
The radio returns automatically to safe mode (access level: NONE) after a period
of time without a button press, or if the radio is powered off and then on.
Use this screen to set or show the transmitter frequency.
Normally, the radio ships configured with the customer-specified frequency. If you
did not specify the operating frequency when the radio was ordered, the factory
sets the TX frequency to the center of the radio's operating band. The range of
frequencies for standard models are provided in
Specifications, beginning on Page
To change the current frequency, press ENTER, then press the left/right arrow
buttons to select a digit. Use the up/down arrow buttons to increase or decrease
the number. Press ENTER to make the change.
MDS 4790/9790 Series I/O Guide
"Set Owner Name" on Page 76
76.
"Set Owner Name" on Page 76
76.
-> ) points to the currently
Section 10.1, Technical
97.
TX [xxxx]
MDS 05-3438A01, Rev. F
and "Set
and "Set
command, Page 58